Need help?Do you have a question about the AC Tech SM250 and is the answer not in the manual?
Explains danger levels and symbols used in safety warnings.
Basic safety advice for operation.
Required input protection standards.
Capacitor discharge warning before servicing.
Wiring practices and disconnects for power.
Critical warnings for power connections.
Keypad, preset, and analog speed references.
Electrical shock and connection hazards.
Steps to check motor rotation.
Accessing program mode via drive interface.
How to set parameter values using buttons.
Using programmer and managing corrupted data.
Calibrates drive for applied input voltage.
Defines start behavior and warnings.
Selects speed reference source.
Configures terminal TB-13A functions.
Configures terminal TB-13B functions.
Configures terminal TB-13E functions.
Selects START/STOP and direction commands source.
Sets acceleration rate.
Sets deceleration rate.
Sets maximum output current.
Motor overload protection settings.
Determines V/Hz ratio for motor.
Selects operation mode or resets parameters.
To Next Page
General