Why am I getting a High DC Bus Voltage Fault on my AC Tech SM450?
A high DC bus voltage fault in AC Tech DC Drives can occur due to several reasons: the line voltage might be too high, the deceleration rate might be too fast, or there could be an overhauling load. For fast deceleration or overhauling loads, dynamic braking may be required.
What to do if AC Tech SM450 show Incompatibility Fault?
If you're encountering an Incompatibility Fault with your AC Tech DC Drives, it means an EPM with an incompatible parameter version has been installed. You can either remove the EPM or perform a factory reset using Parameter 48 to change the parameter version of the EPM to match that of the drive.
How to resolve Control Fault on AC Tech SM450 DC Drives?
A Control Fault in AC Tech DC Drives means that a blank EPM or an EPM with corrupted data has been installed. To resolve this, perform a factory reset using Parameter 48 - PROGRAM SELECTION.
What does External Fault mean on AC Tech SM450?
An External Fault in AC Tech DC Drives is triggered when one of the TB-13 terminals is set as an External Fault input and that terminal is open with respect to TB-11. Refer to Parameters 10, 11, and 12.
Why AC Tech DC Drives show Start Fault?
A Start Fault in AC Tech DC Drives occurs when a start command was present when the drive was powered up. If START METHOD is set to NORMAL, you must wait 2 seconds after power-up to apply the Start command.
What causes Low DC Bus Voltage Fault in AC Tech SM450 DC Drives?
A Low DC Bus Voltage Fault in AC Tech DC Drives indicates that the line voltage is too low.
What does Dynamic Braking Fault mean in AC Tech SM450 DC Drives?
A Dynamic Braking Fault in AC Tech DC Drives means that the drive has detected that the dynamic braking resistors are overheating.
What does Data Fault mean in AC Tech DC Drives?
A Data Fault in AC Tech DC Drives means that user data and OEM defaults in the EPM are corrupted.
Crucial safety guidelines for handling and operating the drive and its components.
Recommended circuit breaker and fuse ratings for safe and compliant installation.
Instructions for correctly connecting input power and output motor wiring to the drive.
Methods for controlling drive start/stop and setting speed references via terminals.
How to program terminals to select different analog speed reference inputs.
Parameters for initial setup like line voltage, carrier frequency, and start/stop methods.
Interpretation of various status, warning, and fault messages displayed by the drive.
To Next Page
General