Accent 1400 Hardware Manual for Dedicated Devices Page 14
Positioning or Removing the Wire Stand
Do not carry the device by the stand. When carrying the device, use the handle or carry strap.
You can use the wire stand in either the closed or open position, or you can remove it completely.
Opening the Wire Stand
The stand in the latched position provides a slight angle for viewing the screen when the device is
sitting on a flat surface.
When the user needs an additional angle, extend the legs of the stand away from the back of the
device by doing the following:
1. Place the device face-down on a flat surface.
2. Snap the stand’s bottom support loose from
its latches on the back of the device.
3. Rotate the stand away from the back of the
device until the legs latch into place.
Wire stand legs
latched in place
To Next Page
Loading...
