Access Interfacing Solutions LSR110 - Prefix and Suffix Solutions

Page 18 of 33 Copyright © Access-IS 2020
Command
Description
Default
Parameters/Range
AISSCP
Sets the connection parameters for a
Serial connection.
Only used when AISINF is set to 0
(Serial).
2
0 - 7N1
1 - 7N2
2 - 8N1
3 - 7E1
4 - 7E2
5 - 8E1
6 - 7O1
7 - 7O2
8 - 8O1
AISKBL
Keyboard localization; this defines the
Windows keyboard mapping for correct
output of characters.
Only used when AISINF is set to 2
(USB keyboard).
0
0 - US (United States)
1 - UK (United Kingdom)
2 - IT (Italy)
3 - ES (Spain)
4 - DE (Germany)
5 - CH (Switzerland)
6 - CZ (Czech Republic)
7 - FR (France)
8 - BE (Belgium)
9 - SE (Sweden)
AISCHR
Sets the inter-character delay (in
milliseconds).
Only used when AISINF is set to 2
(USB keyboard).
2
0–250 milliseconds
AISOMD
Indicator mode setting.
0
0 - Dumb mode
1 - Host mode
2 - Interactive mode
AISTAM
Triggers Auto mode.
Only used when AISOMD is set to 2
(Interactive).
0
0 - Normal operation
1 - Automatic untrigger
when media removed
DLYGRD
Sets the delay between successful
reading of one barcode and the reading
of another barcode.
Each unit is equivalent to 1 millisecond.
2000
0–25000
5.2 Prefix and suffix solutions
These commands allow you to add a prefix and/or suffix to all barcodes.
Note: If you send more than one prefix or suffix to the device, they will stack in chronological order.
You must send a clear command if you want to use a single prefix or suffix.
Table 3. Prefix and suffix commands
Command
Description
Default
Parameters/Range
PREBK299xx
Adds a prefix to all barcode
symbologies.
Any two-character hex ASCII code can
replace xx.
For example, to add STX (Start of Text)
as a prefix, use the command
PREBK29902.
You can add more than one prefix, as
required.
-
xx - Hex value