43
Settings
3
From the last setting “Hypo indicator” pressing the S button takes
you back to the first setting “Beep tone/Acoustic Mode”.
You can close the settings at any time by pressing the Test button.
All settings you have entered up to that point are saved.
Notes
Always turn the meter on with the S button when you intend to
change the settings.
Instead, if you turn the meter on with the Test button and there is
a drum in the meter, a test strip will be advanced.
i
If you turn the meter off with the Test button, it shows you the
number of test strips remaining in the drum (see Chapter 2.3.2).
The meter turns off automatically after approximately 60 seconds
if you do not press a button. All settings you have confirmed up to
that point with the S button are retained. Settings that you have
not confirmed with the S button are lost and the original setting
remains.
man_06919570001_01_EnCan.indd 43 18.01.2013 18:38:06
To Next Page
Loading...
