Accu-Chek Nano User Manual

66
5. Locate the infrared (IR) window on the top of the meter.
6. Locate the IR window on the infrared cable.
7. Place the meter on a flat surface. Point the two IR windows toward each other.
They should be 1–4 inches apart.
8. Do not move the infrared cable or meter during the data transfer.
9. Follow the prompts on the software.
10. The software program may shut o the meter automatically when the data
transfer is complete. Should this occur, follow the prompts on the display.
NOTE
• If the data did not transfer successfully, try again. If you still have problems, contact the ACCU‑CHEK
Customer Care Service Center at 1‑800‑858‑8072.
• To make the most of the transfer feature, you must set the time and date in the meter correctly.
Infrared (IR) Window

Accu-Chek Nano Specifications

General

Display Type	LCD
Sample Size	0.6 µL
Test Time	5 seconds
Memory Capacity	500 results
Automatic Power Off	Yes
Memory	500 results
Dimensions	69 x 43 x 20 mm
Weight	40 g with batteries
Measuring Range	0.6 - 33.3 mmol/L
Operating Conditions	10 - 90% relative humidity