Accu-Chek Performa

23
Meter Memory, Setup, and Data Transfer
3
Press and release to
turn the meter on.
The flashing test strip
symbol appears on the
display.
Press and hold
until
set-up appears on the
display.
1 2
Press and release
repeatedly until the bell
symbol, OFF, set-up, and
the flashing A-1 appear
on the display.
Press and release
or
to switch between On
and OFF.
Press and release
to
set your choice.
If On is selected, the hour
flashes.
3
Press and release or
to adjust the hour.
Press and release
to
set the hour.
The minutes flash.
4
Test reminders:
• beep at the same time each day.
• beep every 2minutes up to 3times.
• turn o by inserting a test strip or pressing
any button.
• If a test was performed within 15minutes
of a test reminder, the test reminder does
not beep.
• If the meter is on at the test reminder time,
the test reminder does not beep.
• Exposure to cold conditions may disable test
reminders until the meter is turned on.
• If a test reminder is o in set-up mode, any
subsequent test reminders are also o. For
example, if you set A-1 but turn o A-2, then
A-3 and A-4 will automatically be o.
Setup
Setting the Test Reminders
NOTE
51746_07022590001.indb 23 7/11/13 1:27 PM