28
Control Tests
4
Touch the drop to the
front edge of the yellow
window of the test strip
until you see flash.
Do not put control
solution on top of the
test strip.
5
When you see flash,
there is enough control
solution in the test strip.
Remove the cap from the
control solution bottle.
Wipe the tip of the bottle
with a tissue.
Squeeze the bottle until a
tiny drop forms at the tip.
4
Insert the test strip into
the meter in the direction
of the arrows.
Place the meter on a flat
surface.
Check the use by date on
the test strip container.
Do not use test strips
past the use by date.
1
Performing a Control Test
You need the meter, a test strip, and control solution Level 1 or Level 2.
Select the control solution
to test. You will enter the
level later in the test.
32
Wipe the tip of the bottle
with a tissue. Cap the
bottle tightly.
or
6
51746_07022590001.indb 28 7/11/13 1:27 PM
To Next Page
Loading...
