4.1 Avoiding Problems
Pre-select the bills you are going to count in the machine. Do not attempt to
count bills:
a. With staples or metal clips
b. Torn or washed
c. Profusely stained
d. Covered with adhesive media (for AB-1100 UV and AB-1100 MG/UV
models, only)
4.2 Jamming
a. Before you start operating the machine, make sure that there are no
foreign elements (such as silica bags) obstructing the moving parts of
the unit.
b. To avoid jamming, load the bills as indicated in this manual. The bill
facing you (in front) will go in rst.
c. If jamming occurs, make sure turn the machine off. Carefully remove the bill
stuck into the rollers. Look for any other foreign object like paper clips,
rubber bands, etc. Remove them if any.
d. Check for proper tightness of the bill thickness adjustment screw.
in the back of the unit.
f. Verify proper placement of the bills on the hopper.
4.0 Troubleshooting
25
Emergency Stop Button
To Next Page
Loading...
