AccuBANKER AB-1100 Plus Basic - Error Messages

6.0 Error Messages
30
MESSAGES POSSIBLE CAUSES
a)Remove the suspicious bill and count again.
b)In case you need it, reduce the UV sensitivity
a)Remove the suspicious bill and count again.
b)In case you need it, reduce the MG sensitivity
a)Two or more bills were fed
b)Bills jammed inside the unit
WIDTH ALARM
A bill thiner than rest
was detected
HALF BILL ALARM
Bill size problem
DOUBLE BILL
ALARM
Two bills are stuck togheter
EMERGENCY
STOP
Emergency stop function is
activated
COUNT SENSOR
ERROR
Problem with the Counting
Sensors
STACKER SENSOR
ERROR
Problem with the Stacker
Sensors
Remove the problematic bill
Turn the unit Off and ON again (RESTART)
Clean the Sensors
Clean the Sensors
SOLUTION
MG ALARM
Remove the problematic bill
Remove the problematic bill
a)Verify the Hopper is not loose
b)Adjust the Hopper if necessary
CHAIN ALARM
UV ALARM
Suspicious UV features
Suspicious MG features