To Next Page

To Previous Page

Troubleshooting

Problem Possible Cause Solution

RemoteCall lights are

flashing

The network

cable is not

connected or

there are

network

difficulties.

Plug the cable back in

or call your IT Dept.

blinking on

Main Screen

The Pulse Unit is

recovering from

a power failure.

Wait 30 seconds and

Pulse Unit should

power back on. No

data will be collected

during this boot up

time.

Web page not

showing data.

If the Pulse unit

has been turned

off for an

extended period

of time, the

pulse’s internal

web data will

need to be

reloaded.

Press the

button on the System

Configuration screen.

This button allows the

web data to be

reloaded The button

will only be displayed

if the system thinks

the web data has been

corrupted or lost.

Counts are not

showing on the Pulse

unit.

The “Show”

option was not

set to “Yes” on

the “Configure

Sensors” screen.

Please follow

instructions for Sensor

Setup under “Setting

up the System”

section.

Brand	Accurate Logic
Model	Pulse Series
Category	Measuring Instruments
Language	English

Accurate Logic Pulse Series User Manual

Table of Contents

Questions and Answers:

Accurate Logic Pulse Series Specifications