55 Aspire 1610
Disassembling the LCD Module
Removing the LCD Bezel
1. See “Removing the Battery” on page 48.
2. See “Removing the Middle Cover” on page 52.
3. See “Removing the Launch Board” on page 52.
4. See “Removing the LCD Module” on page 53.
5. Use plastic tweezers to remove the four screw pads, and then remove the four screws that fasten the LCD
bezel.
6. Snap off the bezel carefully, and then remove the LCD bezel from the LCD module.
Removing the Inverter Board (15” LCD)
1. See “Removing the Battery” on page 48.
2. See “Removing the Middle Cover” on page 52.
3. See “Removing the Launch Board” on page 52.
4. See “Removing the LCD Module” on page 53.
5. See “Removing the LCD Bezel” on page 55.
6. To remove the inverter board, first remove one screw from the inverter board.
7. Disconnect the LCD power cable then disconnect the inverter cable from the inverter board.
To Next Page
Loading...
