67 Aspire 1610
6. See “Removing the CPU Heatsink Plate” on page 64.
7. See “Removing the ODD Module(1)” on page 65.
8. See “Removing the HDD Bracket” on page 65.
9. See “Removing the Main Board” on page 66.
10. Remove the two screws that fasten the DC board. Then detach the DC board from the lower case.
Removing the I/O Port Bracket
1. See “Removing the Battery” on page 48.
2. See “Removing the Middle Cover” on page 52.
3. See “Removing the Keyboard” on page 59.
4. See “Removing the Floppy Disk Drive Module” on page 63.
5. See “Removing the VGA Heatsink Plate” on page 64.
6. See “Removing the CPU Heatsink Plate” on page 64.
7. See “Removing the ODD Module(1)” on page 65.
8. See “Removing the HDD Bracket” on page 65.
9. See “Removing the Main Board” on page 66.
10. Remove the four hex screws to detach the I/O port bracket from the main board.
Removing the PCMCIA Slot
1. See “Removing the Battery” on page 48.
2. See “Removing the Middle Cover” on page 52.
3. See “Removing the Keyboard” on page 59.
4. See “Removing the Floppy Disk Drive Module” on page 63.
5. See “Removing the VGA Heatsink Plate” on page 64.
6. See “Removing the CPU Heatsink Plate” on page 64.
7. See “Removing the ODD Module(1)” on page 65.
8. See “Removing the HDD Bracket” on page 65.
To Next Page
Loading...
