Acer Aspire 1610 series - Removing the ODD Module(1); Removing the ODD Module(2); Removing the HDD Bracket

65 Aspire 1610
Removing the ODD Module(1)
1. See “Removing the Battery” on page 48.
2. Remove the screw that fastens the ODD bracket on the bottom. Push the ODD module at the point the
red arrow indicates hard.Then remove the ODD module from the lower case.
NOTE: If you need to replace the ODD module only, you can remove the ODD module as the steps above.
Removing the ODD Module(2)
1. See “Removing the Battery” on page 48.
2. See “Removing the Middle Cover” on page 52.
3. See “Removing the Keyboard” on page 59.
4. See “Removing the Floppy Disk Drive Module” on page 63.
5. Push the ODD module outwards then take the ODD out of the support bracket. Remove the screw that
fastens the ODD support bracket then remove it.
Removing the HDD Bracket
1. See “Removing the Battery” on page 48.
2. See “Removing the Middle Cover” on page 52.
3. See “Removing the Keyboard” on page 59.
4. See “Removing the Floppy Disk Drive Module” on page 63.
5. Remove the four screws holding the HDD bracket, then remove the HDD bracket.