Acer Aspire 1610 series - Removing the Main Board; Removing the DC Board

Chapter 3 66
Removing the Main Board
1. See “Removing the Battery” on page 48.
2. See “Removing the Middle Cover” on page 52.
3. See “Removing the Keyboard” on page 59.
4. See “Removing the Floppy Disk Drive Module” on page 63.
5. See “Removing the VGA Heatsink Plate” on page 64.
6. See “Removing the CPU Heatsink Plate” on page 64.
7. See “Removing the ODD Module(1)” on page 65.
8. See “Removing the HDD Bracket” on page 65.
9. Disconnect the launch board cable. Tear off the tape that fastens the speaker set cable. Then disconnect
the speaker set cable.
.
10. Remove the two screws holding the main board as the picture shows. Remove another two screws that
fasten the main board. Then detach the main board from the lower case carefully.
Removing the DC Board
1. See “Removing the Battery” on page 48.
2. See “Removing the Middle Cover” on page 52.
3. See “Removing the Keyboard” on page 59.
4. See “Removing the Floppy Disk Drive Module” on page 63.
5. See “Removing the VGA Heatsink Plate” on page 64.