Chapter 3 68
9. See “Removing the Main Board” on page 66.
10. Remove the four screws that secure the PCMCIA slot, then remove the PCMCIA slot from the lower case.
Removing the Speaker Set
1. See “Removing the Battery” on page 48.
2. See “Removing the Middle Cover” on page 52.
3. See “Removing the Keyboard” on page 59.
4. See “Removing the Floppy Disk Drive Module” on page 63.
5. See “Removing the VGA Heatsink Plate” on page 64.
6. See “Removing the CPU Heatsink Plate” on page 64.
7. See “Removing the ODD Module(1)” on page 65.
8. See “Removing the HDD Bracket” on page 65.
9. See “Removing the Main Board” on page 66.
10. See “Removing the DC Board” on page 66.
11. Tear off the tape fastening the speaker set cable. Then remove the four screws that secure the speaker
set. Remove the speaker set from the lower case.
To Next Page
Loading...
