Machine Maintenance 3-31
Removing the Touchpad Board 0
1. Perform the “Removing the Palmrest Module/Upper Cover” procedure described on
page 3-23.
2. Open the connector latch (a) and then disconnect the touchpad cable (b).
Figure 3-39. Touchpad Board Cable
3. Detach the tape securing touchpad board.
Figure 3-40. Touchpad Board Tape
4. Insert a small flat-blade screwdriver between the touchpad board and the upper cover,
and carefully pry the board loose. Remove the touchpad board from the palm rest.
To Next Page
Loading...
