3-14 Machine Maintenance Procedures
4. Remove two (2) screws (E) from ODD module (Figure 3-10).
5. Remove ODD bracket (D) from ODD module (Figure 3-10).
Figure 3-10. ODD bracket Removal
ODD Module Installation 0
1. Install the ODD bracket (D) to the ODD module. Refer to Figure 3-10.
2. Secure two (2) screws. Refer to Figure 3-10.
3. Install the ODD bezel to the module and press down to secure it. Refer to Figure 3-9.
4. Place the ODD module into the ODD bay. Refer to Figure 3-8.
5. Install and secure one (1) screw to the base cover.
6. Install the battery.
ID Size Quantity Screw Type
A M2.5*6.0 1
E M2.0*3.0 2
To Next Page
Loading...
