Machine Maintenance Procedures 3-15
Base Cover Removal 0
Prerequisite:
ODD (Optical Disk Drive) Module Removal
1. Remove twentythree (23) screws from the lower case (Figure 3-11).
2. Remove the base cover.
Figure 3-11. Outside Screws
Base Cover Installation 0
1. Install the base cover and press downward until the tab engages.
2. Secure twenty three (23) screws. Refer to Figure 3-11.
3. Install the ODD.
ID Size Quantity Screw Type
Red Call
out
M2.5*6.0
19
Green
Call out
M2.0*3.0 4
To Next Page
Loading...
