2-8 System Utilities
Security 0
The Security tab shows parameters that safeguard and protect the computer from
unauthorized use.
Figure 2-3. BIOS Security
Table 2-3 describes the parameters shown in Figure 2-3.
When prompted to enter password, three attempts are allowed before system
halts. Resetting BIOS password may require computer be returned to dealer.
InsydeH20 Setup Utility Rev. 3.5
Information Main Security Boot Exit
Item Specific Help
Supervisor Password Is: Clear
Supervisor Password
controls access to the
whole setup utility. It
can be used to boot up
when Password on
boot is enabled.
User Password Is: Clear
HDD Password Is: Clear
Set Supervisor Password [Enter]
Set User Password [Enter]
Set HDD Password [Enter]
Power on Password [Disabled]
F1 Help Select Item F5/F6 Change Values F9 Setup Default
ESC Exit Select Menu Enter Select>SubMenu F10 Save and Exit
Table 2-3. BIOS Security
Parameter Description Option
Supervisor Password Is Supervisor password setting
Clear or Set
User Password Is User password setting
Clear or Set
HDD Password Is HDD password setting
Clear or Set
Set Supervisor Password Option to set supervisor password
N/A
Set User Password Option to set user password N/A
Set HDD Password Option to set HDD password N/A
Password on Boot Shows if password is required during system boot Disabled or
Enabled
SG_JV51_HR.book Page 8 Friday, July 8, 2011 5:58 PM
HTTP://MYCOMP.SU/ - Maintenance and Service Guide,Service Manual,Motherboard Schematics for Laptop/notebook
РЕМОНТ НОУТБУКОВ. Запчасти и комплектующие для ноутбука. Схемы, сервис мануалы, инструкции по разборке ноутбука.
ВОССТАНОВЛЕНИЕ ДАННЫХ. г. Санкт-Петербург, Тел.(812)951-37-99, Тел.8-921-951-37-99,ICQ:573812745, service@it-lux.ru
To Next Page
Loading...
