Machine Maintenance Procedures 3-5
Machine Maintenance Procedures
Introduction 0
This chapter contains general information about the notebook, a list of tools needed to
perform the required maintenance and step by step procedures on how to remove and install
components from the notebook computer.
General Information 0
The product previews seen in the following procedures may not represent the final product
During the removal and installation of components, make sure all available cable channels
and clips are used and that the cables are installed in the same position.
All prerequisites must be performed prior to performing maintenance.
Recommended Equipment 0
The following tools are required to perform maintenance on the notebook:
Wrist grounding strap and conductive mat
Flat screwdriver
Philips screwdriver
Table 3-1. Main Screw List
Screw Name Quantity
M2.5x4.0 21
M2.45x8.0 13
M2.0x3.0+2.0 1
M2.0x5.0 8
M3.0x3.0 4
M2.0x3.0 4
M2.5x3.2 4
M2.0x2.5 8
M2.0x1.6 5
M2x1.6 2
M2.0x3.0 17
SG_JV51_HR.book Page 5 Friday, July 8, 2011 5:58 PM
HTTP://MYCOMP.SU/ - Maintenance and Service Guide,Service Manual,Motherboard Schematics for Laptop/notebook
РЕМОНТ НОУТБУКОВ. Запчасти и комплектующие для ноутбука. Схемы, сервис мануалы, инструкции по разборке ноутбука.
ВОССТАНОВЛЕНИЕ ДАННЫХ. г. Санкт-Петербург, Тел.(812)951-37-99, Тел.8-921-951-37-99,ICQ:573812745, service@it-lux.ru
To Next Page
Loading...
