Machine Maintenance 3-13
Removing the Hold Sensor Board 0
1. Perform the “Removing the Lower Case” procedure described on page 3-7.
2. Perform the “Removing the Battery Pack” procedure described on page 3-8.
3. Release the connector latch (1) from the mainboard, then disconnect the hold sensor
cable (2).
Figure 3-15. Hold Sensor Cable
4. Remove the screw securing the hold sensor board to the upper case assembly.
Figure 3-16. Hold Sensor Board Screw
Table 3-16. Screw
Step Screw Quantity Screw Type
Hold Sensor Board Disassembly M2 x L2 1
To Next Page
Loading...
