Machine Maintenance 3-27
Removing the Mainboard 0
1. Perform the “Removing the Lower Case” procedure described on page 3-7.
2. Perform the “Removing the Battery Pack” procedure described on page 3-8.
3. Perform the “Removing the Left and Right Speakers” procedure described on page 3-10.
4. Perform the “Removing the RTC Battery” procedure described on page 3-12.
5. Perform the “Removing the Hold Sensor Board” procedure described on page 3-13.
6. Perform the “Removing the M-SATA Board” procedure described on page 3-15.
7. Perform the “Removing the Small Fan” procedure described on page 3-17.
8. Perform the “Removing the Big Fan” procedure described on page 3-19.
9. Perform the “Removing the Touchpad Module” procedure described on page 3-22.
10. Perform the “Removing the EL Small Board” procedure described on page 3-25.
11. Release the connector latch (1) from the mainboard, then disconnect the LED indicator
cable (2).
Figure 3-39. LED Indicator Cable
To Next Page
Loading...
