Machine Maintenance 3-17
Removing the Small Fan 0
1. Perform the “Removing the Lower Case” procedure described on page 3-7.
2. Perform the “Removing the Battery Pack” procedure described on page 3-8.
3. Perform the “Removing the M-SATA Board” procedure described on page 3-15.
4. Release the connector latch (1) from the mainboard, then disconnect the small fan cable (2).
Figure 3-23. Small Fan Cable
5. Remove the two screws securing the small fan to the upper case assembly.
Figure 3-24. Small Fan Screws
Table 3-24. Screws
Step Screw Quantity Screw Type
Small Fan Disassembly M2 x L3 2
To Next Page
Loading...
