Machine Maintenance 3-25
Removing the EL Small Board 0
1. Perform the “Removing the Lower Case” procedure described on page 3-7.
2. Perform the “Removing the Battery Pack” procedure described on page 3-8.
3. Release the connector latch (1) from the mainboard, then disconnect the EL small board
cable (2).
Figure 3-36. EL Small Board Cable
4. Release the connector latch (1) from the EL small board, then disconnect the EL small
board cable (2). Detach the cable from the upper case assembly (3).
Figure 3-37. EL Small Board Cable Self Adhesive Tape
To Next Page
Loading...
