System Utilities 2-7
Security 0
Use this tab to safeguard and protect the computer from unauthorized use.
Figure 2-3. BIOS Security
Table 2-3. BIOS Security
Parameter Description Option
Supervisor Password Is Supervisor password setting.
Clear or Set
User Password Is User password setting.
Clear or Set
HDD0 Password Is Primary hard drive password setting.
Clear or Set
Set Supervisor Password Option to set the supervisor password. –
Set User Password Option to set a user password. –
Set HDD0 Password Option to set the primary hard drive password. –
Password on Boot Option to enable password requirement during
system boot.
Enabled or
Disabled
Secure Boot Mode Option to select between two secure boot modes
in firmware setup.
Custom mode provides option to modify the
contents of the Secure Boot signature databases
(PK, KEK, db, dbx).
Standard mode restores the firmware settings to
its factory defaults. Any customized secure boot
variables are also reset to factory defaults.
Standard or
Custom
To Next Page
Loading...
