Jumper and Connector Locations 5-5
Jumper Setting 0
The section explains how to set jumper for correct configuration of the main board.
Setting Jumper 0
Use the mother board jumpers to set system configuration options. Jumpers with more Than
one pin are numbered. When setting the jumpers, ensure that the jumper caps are Placed on
the correct pins.
The illustrations show a 2-pin jumper.When the jumper cap is placed on bothpins,the jumper
is SHORT.If you re-move the jumper cap,or place the jumpercap on just one pin,the jumper is
OPEN.
This illustration shows a 3-pin jumper.Pins 1 and 2 are SHORT.
To Next Page
Loading...
