Acer K130 - Chapter 2 Disassembly Process & Assembly Process; Equipment Needed & Product Overview

K130
Condential
2-1
Chapter 2
Disassembly & Assembly Process
2-1 Equipment Needed & Product Overview
1. Screw Bit (+): No.0
2. Screw Bit (+): No.00
3. Tweezers
4. K130 unit
* Before you start: This process is protective level II. Operators should wear electrostatic
chains.
* Note: If you need to replace the main board, you have to get into service mode and
record the LED usage hour. please refer to section 2-9.