Acer K130 - Assemble Engine Module

K130
Condential 2-12
NOTE: Circuit boards > 10 cm² has been
highlighted with the yellow rectangle
as above image shows. Please
detach the Circuit boards and follow
local regulations for disposal.
2-9 Assemble Engine
module
1. Place DMD rubber and DMD chip to
engine module.
2. place DMD board, DMD board rubber
and heat sink to engine module.
3.Screw 4 screws to assemble heat sink to
Engine module (as red circle)
DMD spongeDMD chip
Engine module
DMD heat sink DMD board rubber
DMD board