K130
Condential 2-11
NOTE: Circuit boards > 10 cm² has been
highlighted with the yellow rectangle
as above image shows. Please
detach the Circuit boards and follow
local regulations for disposal.
2. Unscrew 4 screws to disassemble heat
sink and DMD board (as red circle)
3. Separate DMD heat sink and DMD
board rubber and DMD board from engine
module.
4.Separate DMD chip and DMD sponge
from engine module.
5. Disassemble is completed.
DMD heat sink DMD board rubber
DMD board
DMD spongeDMD chip
Engine module
To Next Page
Loading...
