Acer K130 - Run in Test; Others

Condential
4-11
K130
4-7 Run In Test
- Temperature: 29°C~35°C
- Circumstance brightness: Normal environment
- Screen size: No concern
- Display mode: ECO mode
-
After repairing each unit, it should be Run-in (refer to the below table).
Symptom Run-in Time
Normal repair 2 hours
NFF 4 hours
Auto shut down 6 hours
- Get into Burn-In Mode
*Cyclesettingisbasedonthedefectsymptoms.ie:IfitisNFF,therun-in
timeis4hours.YouhavetosettheLEDonfor60min.andLEDofffor
15 min for 4 cycles.
Note:Pleasemakesurethatthehotexhaustairowsfromprojectorscan
owtowardstheaisle.
Press power > Left > Left > Menu to get into service mode
Choose Burn-In Test > enter
LED On Press right key to adjust the time (60)
LED Off Press right key to adjust the time (15)
Set burn in cycle Press right key to adjust the cycle
After setting up the time, choose “Get into Burn-In Mode” and press enter
4-8 Others
1. Function Inspection
General - All OSD functions must be checked for functionality.
When OSD menu is displayed, there shall be no
visible peaking, ringing, streaking, or smearing