Acer K130 - Page 58

Condential
4-10
K130
is about 0.8~1.0m far away from the projector.
- Connect LED Calibration Fixture and Projector
by VGA Cable.
- Connect LED Calibration Fixture and CL200
by CL200 RS232 Cable.
- Connect LED Calibration Fixture and Computer
by USB Cable.
- Power on the projector and get into Service Mode.
- Select “LED Calibration Settings”, Then enter in
LED Calibration OSD.
- Press “enter” key to start calibration and
“Success” will appear in right blank.
USBCable
CL200RS232Cable VGA(Universal )