Acer S230HL - Page 33

31 ACER S230HL
Go to contents page
4. Assembly and Disassembly Procedures
S4
Put The Main board on the Panel’s UDM.
S5
1: Plugging in connector of Main board(BJ1 conn) and connector of Panel with the
Panel power cable (FFC cable)
2: Using the two kinds of Acetate cloth tapes to stick the Panel power cable on the Panel (Tape 1:20*45,
Tape 2:12*30mm)
S6
1: Taking the wire cable to connect the J1 connector of Main board and J1 connector of OSD key board.
2: Using one Aluminium tape to stick wire cable.(ALUMINIUM TAPE = 21*61mm)
3: Putting the OSD key assembly into the hooks of Front Bezel firmly.
※Don’t let the wire cable touch the cable of panel.