2.6 PnP/PCI System Configuration
The PnP/PCI System Configuration allows you to specify the settings
for your PCI devices.
PnP/PCI System Configuration Page 1/1
PCI IRQ Setting ............[ Auto ]
INTA INTB INTC INTD
*PCI Slot 1............ [--] [--] [--] [--]
*PCI Slot 2............ [--] [--] [--] [--]
*PCI Slot 3............ [--] [--] [--] [--]
*PCI Slot 4............ [--] [--] [--] [--]
PCI IRQ Sharing.............[Yes]
VGA Palette Snoop ..........[Disabled]
Plug & Play OS..............[Yes]
Reset Resources Assignment..[No ]
¯ = Move Highlight Bar, ® ¬ = Change Setting
PgDn/PgUp = Move Screen, F1 = Help, Esc = Exit
2.6.1 PCI IRQ Setting
This parameter allows for Auto or Manual configuration of PCI
devices. If you use plug-and-play (PnP) devices, you can keep the
default setting Auto. The system then automatically configures the
PnP devices. If your PCI device is not a PnP, you can manually
assign the interrupt for each of the device.
Refer to your manual for technical information
about the PCI card.
2-24 User’s Guide
To Next Page
Loading...
