107 Chapter 3
Removing the Power Supply
1. See “Removing the Housing” on page 98. (Remove the left panel only)
2. Disconnect the FDD power connector from the FDD drive and the HDD power connector from the HDD.
3. Disconnect the CD-RW power connector from the CD-RW drive and DVD-ROM power connector from the
DVD-ROM drive.
4. Disconnect the main power connector and 12 Volt. power connector from the main board. Remove the
four screws that hold the power supply to the housing and detach the power supply from the housing
..
Removing the LED Activity Indicators With Power Switch Cable Module
1. See “Removing the Housing” on page 98
2. See “Removing the Front Panel” on page 98
3. Release the latches as shown here and then press the LED activity indicators with power switch cable
module and then detach the whole module from the housing .
4. Disconnect the power LED, hard disk drive activity LED , network activity and power swtich cables from
the main board.
To Next Page
Loading...
