85 Chapter 3
Disassembling the Veriton 5600D/ 5600G
Open the Housing Cover
This section tells you how to open the housing cover when you need to install additional components inside
the system unit.
CAUTION: Before you proceed, make sure that you have turned off the system and all peripherals connected
to it.
Removing the Housing Cover
1. Turn off the system power and unplug all cables.
2. Place the system unit on a flat, steady surface.
3. Turn the two thumbscrews counterclockwise to remove the cover. Set the screws aside. You will need
them when replacing the housing cover.
4. Hold the sides of the cover with both hands. Slide it back about an inch and then gently pull it outward to
detach it
.
Removing the Front Panel
1. See “Removing the Housing Cover” on page 85
2. Release the latches as shown here and then detach the front bezel from the front panel gently in the way
as shown here.
To Next Page
Loading...
