32
(3) Read EDID:
• Read D-SUB/DVI EDID:
1. EDID Type Selection : Choose ‘‘EDID 128 Bytes’’
2. Read EDID : Click “Read EDID”.
3. While complete, it will show message’’ Read EDID OK… ‘’, and the read-out DDC will
show in the table in program.
Important Note :
Be reminded to connect Only One port every time, because the software will not be able to
identify the command signal from which port.
After connecting all equipment, always read DDC before writing DDC to ensure the
connection status is OK for writing DDC.
To Next Page
Loading...
