Acer X1130P - Chapter 3 System Disassembling and Replacement; Main Unit Disassembling

36
Chapter 3 System Disassembling and Replacement
Main Unit Disassembling
Tool : Screw Driver --Hex (#4-40) and Cross(Mechanical : M3,M4, Opt.Engine :M2)
Process :
Step Discription Photo Tool
1
Disassemble the
screw*5(M3*7L)
screw
driver
2
Take off the the IR
sensor wire from
mainboard, then take
off upper case
module,
Notice : When taking
off upper case
module, don't break
the IR sensor wire.
3
Take off the case left
module and the front
case module
keypad braket
2
1
3
4
5
FRONT
IR BD
keypad Rubber
4
(1) Take off screws:
For X1130P :
Disassemble the
screw*2(STAND OFF
XH4#-40*6L).
For X1230PK :
Disassemble the
screw*4(STAND OFF
XH4#-40*6L).
For X1130PA/
X1230P/X1230PA/X12
37: Disassemble the
screw*6(STAND OFF
XH4#-40*6L)
(2) Take off the rear
case.
screw
driver
1
2
3
4
rear case
1
2
For X1130P:
For X1230PK:
For X1130PA/X1230P/X1230PA/X1237:
1 2
3 4 5
6