Acer X1130P - Page 49

49
Fig.7-2-1
Fig.7-2
7.4 Assemble Thermal Pad & Gasket Hest-sink then place contact DMD (Fig. 7-3).
i. Pre-fastening Sequence: [ 1 ] - [ 2 ] - [ 3 ] - [ 4 ].
ii. Fastening Sequence: [ 2 ] - [ 1 ] - [ 4 ] - [ 3 ].
iii. Screw Torque must be confirmed to be 6 kg-cm.
Fixed shafts of
DMD HSG
Fixed holes of DMD