4.1.9 UPDATE
Update menu is used for updating the software for addition of a function and correction of a bug of
MD2000-16H. When the MD2000-16H product is used alone, it can be updated with new software via
FTP. If the product is used with the NMS, it can be updated with new software.
STEP 1) With the FTP program, upload of software or font file of
MD2016A. Refer to “ANNEX 1. Product Update”
STEP 2) After the completion of uploading, when the [MENU] button is
pressed, the main menu would appear. Select “UPDATE” from the
main men and then press [ENTER].
STEP 3) When software for update is uploaded, information on the
uploaded software file version would be indicated just like the [Figure
40].
STEP 4) To apply the changed setup, select “APPLY” with the
[Up/Down] button. To not apply the changed setup, select
“CANCEL”.
1. It would take a couple of minutes for updating..
2. “Do not turn off the product while updating.” Turning off while updating could cause a
tremendous damage on the product. .
4.1.10 INITIALIZATION
It is for initializing of the MD2000-16H back to default values.
Must note that the initialization would initialize all the setups of the product.
STEP 1) When the [MENU] button is pressed, the main menu would
appear. Select “INITIALIZATION” and then, press [ENTER].
STEP 2) For initialization, press “APPLY”. To cancel the initialization,
press “CANCEL”.
To Next Page