ALWAYS A STEP AHEAD 11
EN
5.2 Maintenance intervals and wear parts
All units are designed for 24/7-operation. This results in highest requirements to components and
materials. To ensure the reliable operation under these harsh conditions we recommend to regu-
larly replace the following components:
Component Exchange after Note
Mass storage 30,000 hours of operation
*1
Data backup is recommended
Display panel 30,000 hours of operation No pretreatment required
Cable glands in cable
cover
If necessary
Clearly visible abrasion indicates the need to change the
grommets
*1 The Lifetime of your flash memory depends on various external aspects. High ambient tempe-
rature, a high storage utilization as well as a large number of writing operations, especially when
writing lots of smaller files, will strain your memory additionally. Depending on your operation
environment other intervals might be reasonable.
We would be glad to submit an offer for these maintenance tasks.
No consumables are required to operate the unit.
5.3 Malfunctions and alarm signals
Shut the unit down if you discover any mechanical damage to the housing, display or service
cables. In this case the unit must be checked by qualified service personnel. Operation of the unit
with damaged components can cause further damage.
Please register malfunctioning units with the link in the QR code below or via the contact details in
section 6. You will also find the current ACL warranty conditions.
Source: https://www.qrcode-monkey.com/de/#
Link: https://www.acl.de/en/rma-anfrage
Font: MyriadPro Regular 50pt
Scan Test: min. Size 8mm on FinalCheck, orange Scanner
RMA
https://www.acl.de/en/rma-request
Disconnect the unit from the mains immediately in the following cases and get in contact with the
manufacturer or authorized service technician:
• unusual odor or smoke
• high level of heat emissions from the unit
• damage to the power cable or plug
• malfunctions although you followed the operating instructions
• substantial changes in the unit’s behavior that indicate that it needs service
• mechanical damage to the unit or to its frontal glass (such as due to a fall)
• unusual noises from the unit during operation
To Next Page
Loading...
Need help?
General