ALWAYS A STEP AHEAD 3
EN
3. Installation and commissioning
The unit was cleaned before leaving our production facility. However, it is neither sterile nor
disinfected upon arrival due to transport conditions and packing. Advice for initial cleaning can be
found at section 5.1.
Make sure that the unit and its accessories are complete according to the attached delivery note.
Keep the original packaging material for the event that it might have to be transported back.
The integrated VESA interface on the rear can be used to flexibly attach the unit to mounting solu-
tions and other devices. Various manufacturers offer adapters and installation solutions for this.
We would be pleased to offer customized installation solutions on your request.
The unit may only be operated in an upright position. Do not operate it in any direction at an incli-
nation of more than 30° from the norm. The only units that may be operated with a screen rotated
at 90° (portrait mode) are those specially designated as such (e.g., portrait models). To prevent the
unit from being damaged it is not allowed to operate it in impermissible positions such as rever-
sed, upside down and lying on its back or display.
Only use the screws supplied and always use all fastening screws (orange) for correct and save
assembly.
To Next Page
Loading...
Need help?
General