ACT ACTENTRY A5 - Relay Timers; Relay Configuration

ACTentry A5 Operating and Installation Manual Rev 1.1
ACTentry A5 Programming
On the Entry Panel, press the button followed by the programming code (initially 9999). The
CALL led will flash amber while in programming mode. If is pressed at any time or no key is
pressed within 30 seconds, programming mode is exited.
PIN Code Management
Changing User PIN Codes:
Step Keypad Entry Operation Example: Assign code 7529 to User 7
1 xxxx Enter Programming Mode
9999
Enter Programming Mode
2 0 Change PIN codes 0 Change PIN codes
3 0-9 Enter User Number 0-9 7 User 7
4 0000-9999 4 digit code 7529 PIN code
5
Exit programming
Exit programming
Example: To assign code 7529 to User 7 press: 9999 0 7 7529
Deleting User PIN Codes:
Step Keypad Entry Operation Example: Delete User 7 code
1
xxxx
Enter Programming Mode
9999
Enter Programming Mode
2 0 Change PIN codes 0 Change PIN codes
3 0-9 Enter User Number 0-9 7 User 7
4 0000-9999 0000 deletes User code 0000 PIN code
5
Exit programming
Exit programming
Example: To delete User 7code press: 9999 0 7 0000
Changing Programming Code:
Step Keypad Entry Operation E.g. Set Programming code to 8282
1
xxxx
Enter Programming Mode
9999
Enter Programming Mode
2 0 Change PIN codes 0
3
Change Programming code (Default 9999)
4 0000-9999 New 4 digit programming code 8282 New Programming Code
5
Exit programming
Exit programming
Example: To set Programming code to 8282 press: 9999 0 8282
11