4. Patrol for Leakage: Connect the meter
to the vehicle’s antenna through your
vehicle’s docking station. Turn your
meter “ON”, set-up your leakage
screen, check for the “Measurement
Mode”, and vehicle antenna icon.
Adjust your alarm signal and start to
patrol.
5. During Patrol: Look for leakage
sources by listening for rapid alarm
signals when driving. Observe the
field strength in the leakage screen
and the peak level while the alarm
detects leakage sources in the area.
Identify a leak source with a leakage
potential of 20 µV/m or more. After a
general leak site is identified, stop the
vehicle and locate the specific leakage
source. Note: Always check with poli-
cies set by your cable system regard-
ing minimum leakage levels required.
6. Locate Specific Leakage Source:
Disconnect your meter from the dock-
ing station and connect your meter to
an HD-1 hand-held dipole antenna.
7. Set Your Meter: Turn “ON” your leak-
age screen, select the dipole antenna
from the leakage screen, clear the old
peak reading, and select the “Find &
Fix” Mode.
1-2
Peak hold high-
est level reading.
Current leakage
level.
To Next Page
Loading...
