~ Measure a Leakage Source
for FCC or CENELEC
Compliance
In this section of the manual, we have
pinpointed a critical leakage source
greater than 20 µV/m, which is not
FCC compliant. Therefore, we must
take a site specific leakage reading
using FCC guidelines. Use the follow-
ing procedures to complete a FCC
compliant field measurement.
10. If an FCC measurement is not
required, repair the leak.
12. After the leakage source is
repaired, check for other leakage
sources in the area.
4-10
To Next Page
Loading...