HARDWARE MANUAL
22
3. Insert the clamping nut through the flex conduit.
4. Insert the sealing rubber and attach it at the end of the flex conduit.
5. Attach the conduit gland body to the hole of the camera.
Attach to Camera Side Hole Attach to Camera Bottom Hole
NOTE: The following images are taken using the side hole of the camera; the same
procedures apply when using the bottom side hole.
6. If the cables will be routed along the surface, mount the camera to the surface first
before doing the succeeding cabling procedures. See Step 4: Install the Camera to the
Surface on page 24.
To Next Page
Loading...
