ACTi Z83 - Z810

www.acti.com
Hardware Manual
10
Z810
Item
Description
1
DC 12V Power Input
In case the camera is connected to a non-PoE (Power over
Ethernet) switch, use this connector to connect the camera to an
external power adapter (not included). See How to Connect a
Power Adapter (Optional) on page 21 for more information.
2
Audio Input / Output
Connects to audio input / output devices, such as a microphone
with built-in amplifier or speaker, etc. See How to Connect
DI/DO Device (Optiona on page 22 for more information.
3
Digital Input / Output
This connector connects to digital input or output devices, such
as an alarm trigger, panic button, etc. Digital Input (DI) and
Digital Output (DO) devices are used in applications like motion
detection, event triggering, alarm notifications, etc. See How to
Connect DI/DO Device (Optiona on page 22 for more
information.
4
Ethernet Port
Connects to a network using an Ethernet cable with RJ-45
connector.
5
Built-in Microphone
Receives audio input.
6
Reset Button
Restores the camera to its factory default settings. To reset the
camera, use a pin to press and hold the Reset Button for about
15 seconds.
7
Memory Card Slot
Insert a memory card into this slot for local recording purposes.