Hardware Manual
21
Other Cable Connections
This section describes the procedures in attaching the Ethernet cable connector, preparing and
connecting an external power adapter, digital input and output (DI/DO) device, such as alarms,
sensors, etc., and audio input and output devices. The use of these devices, however, is optional.
NOTE: If these connectors will not be used, make sure to wrap them with waterproof tape to
avoid water or dust from entering the connectors.
How to Connect a Power Adapter (Optional)
The camera can be powered by a Power over Ethernet (PoE) switch that is IEEE802.3af
compliant. In case of using a non-PoE switch or your PoE switch has limited power supply, you
can purchase a power adapter and directly connect the camera to a power outlet.
After connecting the power adapter, make sure to protect the cable connection.
NOTE: The power adapter is not bundled in the package.
To Next Page
Loading...
