57
Chapter 5 Setting Up Static IP
11. Click “Save and Restart” at the bottom of the screen.
12. The “Save and Restart” page appears. Click “Save and Restart” to save the set-
tings changed in the Change Admin Username/Password screen.
The Gateway has been configured to support a single static IP address. Once the
Power light stops blinking, the Gateway is ready for use.
Configuring for a Block of Static IP Addresses
To set up the Gateway to use a block of static IP addresses:
☞
Note: To complete this procedure, you must have access to the
Internet Service Provider (ISP) worksheet. If no worksheet has
been provided, contact the ISP.
1. Open the Web browser. In the address bar enter:
http://192.168.0.1
then press Enter on the keyboard.
2. The “Main Menu” screen appears. Select Setup/Configuration.
To Next Page
Loading...
Need help?
General
