ActionTec GT701-WG - NAT (Network Address Translation); Static Routing

82
Actiontec 54 Mbps Wireless DSL Gateway User Manual
83
Chapter 6 Advanced Setup
NAT (Network Address Translation)
Selecting NAT in the “Configuring the Advanced Settings” screen generates the
“NAT” screen. The Gateway’s basic firewall security is based on NAT. Disabling NAT
allows the computers connected to the Gateway to be accessed by outside parties.
Do not turn NAT off unless instructed to do so by the Internet Service Provider
(ISP).
Static Routing
Selecting Static Routing in the “Advanced Settings” screen generates the “Static
Routing” screen. Enter the addresses in their respective text boxes, then click Add.
The address will appear in the “Static Routing Table.” To remove an address, high-
light it by clicking on it in the Static Routing Table, then click Remove.